Cutting a bolt with a thin 3V knife Media
Published: 6 years ago
Cutting a bolt with a thin 3V knife
This is a steel 1/4-20 bolt. I'm cutting this with a relatively thin knife made of Delta 3V that is sharpened at a relatively acute edge angle of 18 degrees per side. The purpose of this video is to demonstrate that steel will support this kind of geometry even in rough use.
This is a steel 1/4-20 bolt. I'm cutting this with a relatively thin knife made of Delta 3V that is sharpened at a relatively acute edge angle of 18 degrees per side. The purpose of this video is to demonstrate that steel will support this kind of geometry even in rough use.