Tormach 1100MX V2.x Control Board Swap - Old Red to New Green - ATC USB or Fuse Error Media
Published: 2 years ago
If you got an ATC USB cable or Fuse error on your Tormach 1100MX, or if you boot up your Tormach 1100MX and PathPilot won't find the ATC this could be your issue.
I contacted Tormach about this error and after a couple of quick trouble shooting steps asking what lights were on the ATC board they determined this was a known issue with the Red control boards and they sent me a new green one. With then new green board you also remove the large Stepper Driver in the cabinet as the new board has the stepper driver integrated.
When the machine turned off the ATC in settings and automatically went back to manual tool changes, I was not even able to do those. When I hit the tool change button on the side of the ATC there was not action. Tormach did send information about what airline to move to get manual back up and running right away. The new board was sent overnight and it was not to hard to install the new one.
I hope this video gets you up and running if you experience this issue.
Thanks for watching!
I contacted Tormach about this error and after a couple of quick trouble shooting steps asking what lights were on the ATC board they determined this was a known issue with the Red control boards and they sent me a new green one. With then new green board you also remove the large Stepper Driver in the cabinet as the new board has the stepper driver integrated.
When the machine turned off the ATC in settings and automatically went back to manual tool changes, I was not even able to do those. When I hit the tool change button on the side of the ATC there was not action. Tormach did send information about what airline to move to get manual back up and running right away. The new board was sent overnight and it was not to hard to install the new one.
I hope this video gets you up and running if you experience this issue.
Thanks for watching!